2026-07-28

Sensor - Crash Accelerometer - LH (Remove and Replace)

Código de corrección 20201152 FRT 0.36 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección y el FRT mencionados anteriormente reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver información sobre prácticas de trabajo seguras.

Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos.
  • 2026-06-24: Released new procedure.
  1. Open the LH front door.
  2. Lower the LH front window.
  3. Open the hood.
  4. Power off the vehicle using the touchscreen.
  5. Remove the rear underhood apron.
  6. Disconnect the LV battery connector and First Responder Loop.
  7. Remove the RH underhood apron.
  8. Remove the LH underhood apron.
  9. Remove the front underhood apron.
  10. Remove the underhood storage unit access panel.
  11. Remove the underhood storage unit carpet.
  12. Remove the underhood storage unit from the vehicle.
  13. Disconnect connector from shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x connector, pull red locking tap
  14. Removed bolt from sensor
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x bolt, 10mm, 7Nm
  15. Remove shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x tab
  16. Install shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x tab
  17. Install bolt in sensor
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x bolt, 10mm, 7Nm
  18. connect connector to shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x connector, push red locking tap
  19. Install the underhood storage unit.
  20. Install the underhood storage unit carpet.
  21. Install the underhood storage unit access panel.
  22. Install the front underhood apron.
  23. Install the LH underhood apron.
  24. Install the RH underhood apron.
  25. Connect the First Responder Loop and LV battery connector.
  26. Install the rear underhood apron.
  27. Close the hood.
  28. Calibrate LH and RH Falcon Wing doors from center display
    Informational PurposesAn informational icon, calling your attention
    Nota
    Calibration required after LV system is powered down > Service > Calibrate Doors > Hold down Calibrate doors until doors cycle > Calibration Complete Message will appear
  29. Raise the LH front window.
  30. Close the LH front door.