2025-09-11

Bracket - Load Floor - LH (Model YL) (Remove and Replace)

Correction code 15301600602 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Install

  1. Position the LH load floor bracket onto the vehicle, and then secure the clips (x5).
    Informational PurposesAn informational icon, calling your attention
    Note
    Confirm each clip installation with push-pull test to make sure the bracket seats properly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not adjust the clip position after the bracket is removed. Otherwise, the bracket will not seat properly during installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the clip position is changed or the push-pull test shows that the bracket is not secure, remove the clip from the tab, and then seat the clip into the doghouse on the bracket and reinstall.
  2. Install the trunk sill trim. See Trunk Sill Lower Trim (Remove and Replace).
  3. Install the trunk load floor. See Trunk Load Floor (Model YL) (Remove and Replace).