2026-03-11

Side Shield Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Replace)

Correction code 13080202302 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-03-11: Updated the steps to release the inboard/outboard side shield.

Remove

  1. Remove the LH 2nd row seat recliner switch button. See Recline Button - Switch - 2nd Row - LH (Model YL) (Remove and Replace).
  2. Remove the LH 2nd row seat cushion switch button. See Button - Cushion Adjust - 2nd Row - LH (Model YL) (Remove and Replace).
  3. Remove the LH 2nd row side shield assembly. See Side Shield Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Install).
  4. Remove the screws (x3) that attach the seat switch to the LH 2nd row seat side shield assembly, and then separate the switch from the assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  5. Release the clips (x4) that attach the armrest switch to the LH 2nd row seat side shield assembly, and then push the switch inward to detach it from the assembly.

Replace

  1. Install the armrest switch to the LH 2nd row side shield welding assembly by engaging all clips (x4) until an audible click is heard confirming correct seating.
  2. Install the screws (x3) that attach the seat switch to the LH 2nd row seat side shield assembly.
    0.7 Nm (6 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Install the LH 2nd row side shield assembly. See Side Shield Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Install).
  4. Install the LH 2nd row seat cushion switch button. See Button - Cushion Adjust - 2nd Row - LH (Model YL) (Remove and Replace).
  5. Install the LH 2nd row seat recliner switch button. See Recline Button - Switch - 2nd Row - LH (Model YL) (Remove and Replace).