2025-11-25

VCUSB Assembly - Center Console (Model YL) (Remove and Replace)

Correction code 15190200102 FRT 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Install

  1. Install the VCUSB assembly. See VCUSB Assembly - Center Console (Model YL) (Remove and Install).
  2. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
  3. In Toolbox, click the Actions tab, type "TEST-SELF_VCUSB_X_HVAC-ACTUATOR" into the search field, click TEST-SELF_VCUSB_X_HVAC-ACTUATORvia Toolbox:(link), click Run, and allow the routine to complete.
  4. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
  5. Disconnect the laptop.
  6. On the touchscreen, press and hold the Exit Service Mode button to exit Service Mode Plus.
  7. Raise all windows and close all doors.