2025-12-19

Damper Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Replace)

Correction code 13020121002 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices. d

  • 2025-12-19: Released new procedure.

Remove

  1. Remove the LH 2nd row seat back panel assembly. See Panel - Seat Back - 2nd Row Seat - LH (Model YL) (Remove and Replace).
  2. Remove the bolts (x3) that attach the LH 2nd row headrest frame to the seat shell.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SKT, 1/4" DR, DEEP, 10MM
  3. Remove the bolts (x2) that attach the LH 2nd row seat back damper to the seat shell.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SKT 1/4" DR, HEX BIT, T25 TORX

Install

  1. Install the bolts (x2) that attach the LH 2nd row seat back damper to the seat shell.
    2.7 Nm (2.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SKT 1/4" DR, HEX BIT, T25 TORX
  2. Install the bolts (x3) that attach the LH 2nd row headrest frame to the seat shell.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SKT, 1/4" DR, DEEP, 10MM
  3. Install the LH 2nd row seat back panel assembly. See Panel - Seat Back - 2nd Row Seat - LH (Model YL) (Remove and Replace).