2025-09-18

Frame - Back Rest - Driver (Model YL) (Remove and Install)

Correction code 13010200201 FRT 1.26 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Torque Specifications

Table 1. Torque Specifications: Frame - Back Rest - Driver (Model YL) (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Inboard and outboard bolts (x4) that attach the seat back frame to the seat cushion frame
43 Nm (31.7 lbs-ft)
  • Torx T50 socket
 Replace 1128435-00-C

Remove

  1. Remove the driver seat back cover and foam assembly. See Cover - Back Rest - Driver Seat (Model YL) (Remove and Replace).
  2. Remove the driver headrest post guide. See Headrest Post Guide - Driver Seat (Model YL) (Remove and Replace).
  3. Remove the driver seat LH and RH insulators. See Insulator - Back Rest - Driver - LH (Model YL) (Remove and Replace).
  4. Remove the driver seat outboard side shield carrier. See Carrier - Side Shield - Outboard - Driver Seat (Model YL / Model Y Performance) (Remove and Replace).
  5. Remove the driver seat inboard side shield carrier. See Carrier - Side Shield - Inboard - Driver Seat (Model YL) (Remove and Replace).
  6. Remove and discard the inboard and outboard bolts (x4) that attach the seatback frame to the seat cushion frame.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  7. Rotate the seatback frame away from the cushion frame, and lift the seatback frame straight up to remove it from the cushion frame.

Install

  1. Place the seatback frame onto the cushion frame for installation.
  2. Install new inboard and outboard bolts (x4) that attach the seatback frame to the seat cushion frame.
    43 Nm (31.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  3. Install the driver seat outboard side shield carrier. See Carrier - Side Shield - Outboard - Driver Seat (Model YL / Model Y Performance) (Remove and Replace).
  4. Install the driver seat inboard side shield carrier. See Carrier - Side Shield - Inboard - Driver Seat (Model YL) (Remove and Replace).
  5. Install the driver seat LH and RH insulators. See Insulator - Back Rest - Driver - LH (Model YL) (Remove and Replace).
  6. Install the driver seat headrest post guide. See Headrest Post Guide - Driver Seat (Model YL) (Remove and Replace).
  7. Install the driver seat back cover and foam assembly. See Cover - Back Rest - Driver Seat (Model YL) (Remove and Replace).