2026-04-20

Trim - B-Cover Inboard Outer - 2nd Row Seat - LH (7-Seat) (Remove and Replace)

Correction code 1308020602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-01-26: Released new procedure.

Remove

  1. Open all four doors.
  2. Lower all four windows.
  3. Move RH front seat forward.
  4. Position LH seat into easy entry mode.
  5. Remove 2nd row LH seatback assembly toe kick panel.
  6. Move LH seat to original position.
  7. Move LH seat fully rearward using towel bar.
    Informational PurposesAn informational icon, calling your attention
    Note
    With one hand on towel bar pull up and slide the seat forward with your other hand.
  8. Position RH seat into easy entry mode.
    Informational PurposesAn informational icon, calling your attention
    Note
    Press shoulder switch and push 40 seat forward to position into easy entry mode.
  9. Release clips and remove inboard outer trim from 2nd row LH seat cushion assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use trim tool to unclip 3x clips and remove inboard outer trim towards rear of the vehicle.

Install

  1. Install inboard outer trim to LH seat.
  2. Install LH toe kick cover.
  3. Move LH seat to original position.
    .
  4. Move RH seat to original position.
  5. Move RH front seat to original position.
  6. Raise all four windows
  7. Close all four doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    If LV is powered up then unlatch rear doors before closing.