2025-07-15

Riser Assembly - Instrument Panel - LH (6-Seat) (Remove and Replace)

Correction code TBD FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Riser Assembly - Instrument Panel - LH (6-Seat) (Remove and Replace) / Riser Assembly - Instrument Panel - RH (6-Seat) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
13 mm bolt and nut that attach the LH/RH IP (instrument panel) riser bracket to the vehicle
25 Nm (18.4 lbs-ft)
  • 13 mm socket
 Reuse
10 mm bolt that attaches the LH/RH IP (instrument panel) riser bracket to the vehicle
6 Nm (4.4 lbs-ft)
  • 10 mm deep socket
 Reuse

Remove

  1. Remove the center console. See Center Console (Without the Key Card Assembly) (6-Seat) (Remove and Install).
  2. Remove the bolts (x2) and the nut that attach the LH IP (instrument panel) riser bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • 10 mm deep socket
  3. Remove the LH IP riser bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently move the left side of the air distribution box backward, and then lift the riser bracket upward to remove it.

Install

  1. Install the LH IP riser bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently move the left side of the air distribution box backward, and then insert the riser bracket downward.
  2. Install the bolts (x2) and the nut that attach the LH IP (instrument panel) riser bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The 13 mm bolt and nut are 25 Nm, the 10 mm bolt is 6 Nm.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • 10 mm deep socket
  3. Install the center console. See Center Console (Without the Key Card Assembly) (6-Seat) (Remove and Install).