2025-09-11
Insulator - Wheelhouse - Rear - RH (Model YL) (Remove and Replace)
Correction code
15301000902
FRT
0.84
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the RH quarter cavity NVH stuffer. See NVH Stuffer - Quarter Cavity - RH (Model YL) (Remove and Replace).
-
Cut the LH rear wheelhouse insulator
near the LH body harness to allow the harness to be routed out of the insulator's
opening hole.
-
Remove the LH rear wheelhouse
insulator from the vehicle.
Install
- If installing a new insulator: cut the LH rear wheelhouse insulator near the LH body harness to allow the harness to be routed into the insulator's opening hole.
-
Install the LH rear wheelhouse
insulator to the vehicle.
- Install the RH quarter cavity NVH stuffer. See NVH Stuffer - Quarter Cavity - RH (Model YL) (Remove and Replace).