2026-03-12

Door - Charge Port (CCS2) (Model Y L) (RHD) (Remove and Replace)

Correction code NEW 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the charge port assembly. See Charge Port (CCS2) (Model Y L) (RHD) (Remove and Replace).
  2. Disconnect the charge port harness connector from the charge port ECU.
  3. Release the charge port door harness grommet from the body.
  4. Release the lower clips (x2) that attach the charge port door to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the bottom clips, then push the bottom of the charge port door out.
  5. Gently pull the charge port door away from the body to remove the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the assembly towards the rear of the vehicle. When the door actuator reaches to the rear of the quarter panel, pull the charge port down to clear the actuator mechanism, then pull out and away from the body. Manipulation of the charge port door may be necessary to fully remove the assembly.

Install

  1. Install the charge port door onto the vehicle (2x clips).
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the part by pivoting the assembly so the actuator mechanism clears underneath the quarter panel, then slide the charge door forward toward the rear door. Manipulation of the charge door may be necessary to fully align the assembly to the body.
  2. Secure the charge port door harness grommet to the body.
  3. Connect the charge port door connector to the charge port ECU.
  4. Install the charge port assembly. See Charge Port (CCS2) (Model Y L) (RHD) (Remove and Replace).