2025-09-11

Trim - C-Pillar - Upper - LH (Model YL) (Remove and Replace)

Correction code 15180100902 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Trim - C-Pillar - Upper - LH (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the 2nd row LH lower seat belt anchor to the body
35 Nm (25.8 lbs-ft)
  • 13 mm socket
  • Torque wrench with angle measurement
 Replace

Remove

  1. Remove the LH 3rd row B section duct. See Duct - B Section - 3rd Row - Upper - LH (Model YL) (Remove and Replace).
  2. Remove and discard the bolt that attaches the 2nd row LH lower seat belt anchor to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • Torque wrench with angle measurement
  3. Feed the seat belt through the LH C-pillar upper trim, and then remove the trim from the vehicle.

Install

  1. Feed the seat belt through the LH C-pillar upper trim.
  2. Install a new bolt that attaches the 2nd row LH lower seat belt anchor to the body.
    35 Nm (25.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • Torque wrench with angle measurement
  3. Install the LH 3rd row B section duct. See Duct - B Section - 3rd Row - Upper - LH (Model YL) (Remove and Replace).