2026-03-12

Steering Gear (RHD) (Model Y L) (Remove and Replace)

Correction code NEW FRT 1.68 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-03-12: Released new procedure.

Install

  1. Mark the threads on the RH inner tie rod and nut on the new steering gear assembly using a paint pen.
    Informational PurposesAn informational icon, calling your attention
    Note
    Mark the original location to assist in reinstalling to the similar position.
  2. Loosen the jamb nut on the LH outer tie rod, and then turn the outer tie rod end counterclockwise to remove tie rod end from the new steering gear assembly.
    80 Nm (59.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Combination Wrench 12pt 21mm
  3. With assistance, turn the steering rack assembly fully to the right using a wrench to disperse the pressure.
  4. Install the steering gear assembly. See Steering Gear (RHD) (Model Y L) (Remove and Install).
  5. Reinstall the software. See Software Reinstall - Touchscreen.