2025-09-11

Power Socket - Rear Trunk (Model YL) (Remove and Replace)

Correction code 15301600002 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Disconnect the LV power. See LV Power (Disconnect and Connect) (Modify).
  2. Remove the LH load floor bracket. See Bracket - Load Floor - LH (Model YL) (Remove and Replace).
  3. Release the clips (x5) and locator pin that attach the edge of the LH trunk side trim to the vehicle, and then carefully pull back the top edge of the trim.
  4. Insert an inflatable air bag to the gap between LH trunk side trim and the vehicle, and then inflate the air bag to gain access to the working area.
  5. Disconnect the rear trunk power socket 12V connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid pulling the connector wiring. Press and pull to release the connector.
  6. Release the hooks (x2) that attach the electrical harness to the LH trunk side trim.
  7. Release the rear trunk power socket 12V connector from the LH trunk side trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the connector upwards until it clears the mounting tab.
  8. Open the power socket 12V cover.
  9. Gently push the rear trunk power socket 12V forward, while simultaneously pulling the upper and lower mount tabs outward to release the power socket 12V from the LH trunk side trim, and then remove the power socket 12V from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Pick Miniature Soft Grip, 90 degree tip, 6 in

Install

  1. Position the rear trunk power socket 12V on the vehicle, insert the connector first, followed by the mount, and then the power socket 12V outlet. Gently push the outlet with the cover facing upwards to secure in place.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure proper fitment of the power socket 12V.
  2. Close the power socket 12V cover.
  3. Install the rear trunk power socket 12V connector on the LH trunk side trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the connector downwards until fully lowered on the mounting tab.
  4. Install the hooks (x2) that attach the electrical harness to the LH trunk side trim.
  5. Connect the rear trunk power socket 12V connector.
  6. Deflate and remove the inflatable air bag from the gap between LH trunk side trim and the vehicle.
  7. Install the clips (x5) and locator pin that attach the edge of the LH trunk side trim to the vehicle.
  8. Install the LH load floor bracket. See Bracket - Load Floor - LH (Model YL) (Remove and Replace).
  9. Connect the LV power. See LV Power (Disconnect and Connect) (Modify).