2025-09-11
Insulator - Back Rest - Driver - LH (Model YL) (Remove and Replace)
Correction code
13010200602
FRT
0.42
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
Seat base edges are
sharp and can cause personal injury. Wear cut resistant gloves when removing the seat
from the vehicle, and while performing procedures that involve work on or near the seat
base.
Remove
- Remove the driver seat back lumbar support. See 1st Row Power Lumbar Seatback - LH (Model YL) (Remove and Install).
-
Release the tabs (x2) of the driver
seat back plastic insulator, and then pull the insulator downward to remove it from the
driver seat back frame.
Install
-
Engage the tabs (x2) that attach the
plastic insulator to the driver seat back frame.
- Install the driver seat back lumbar support. See 1st Row Power Lumbar Seatback - LH (Model YL) (Remove and Install).