2026-04-30

Foam - Seat Cushion - 2nd Row - LH (Model YL) (Remove and Replace)

Correction code 13080202902 FRT 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-04-30: Added steps to remove/install the casing of the occupancy sensor connector.

Remove

  1. Remove the LH 2nd row seat cushion trim assembly from the foam assembly, remove the casing from the occupancy sensor connector, then discard the foam with heat pad and occupancy sensor on it. See Trim - Cushion - 2nd Row Seat - LH (Model YL) (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    Keep the casing for installation as the new part does not come with a casing.

Replace

  1. Remove the adhesive film from a new occupancy sensor, route its connector through the notch of a new seat cushion foam, stick the sensor onto the foam.
  2. Peel off the double-sided tape on the back of a new seat cushion heat pad, then stick it onto the seat cushion foam.
  3. Install the casing onto the new occupancy sensor connector.
  4. Install the LH 2nd row seat cushion trim assembly. See Trim - Cushion - 2nd Row Seat - LH (Model YL) (Remove and Replace).