2025-09-11

Airwave Assembly - Center Console (Model YL) (Remove and Replace)

Correction code 15190201802 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Airwave Assembly - Center Console (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the airwave assembly to the rear display
1.2 Nm (.9 lbs-ft)
  • Torx T20 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Replace 1096312-00-C
Screws (x2) that attach the airwave assembly to the vent cover panel assembly
0.8 Nm (7 lbs-in)
  • Torx T20 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Reuse

Remove

  1. Remove the extension harness assembly. See Extension Harness Assembly - Center Console - Premium (Model YL) (Remove and Replace).
  2. Remove and discard the screws (x2) that attach the airwave assembly to the rear display.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Remove the screws (x2) that attach the airwave assembly to the vent cover panel assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  4. Remove the airwave assembly from the vent cover panel assembly.

Install

  1. Position the airwave assembly to the vent cover panel assembly.
  2. Install the screws (x2) that attach the airwave assembly to the vent cover panel assembly.
    0.8 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install new screws (x2) (1096312-00-C) that attach the airwave assembly to the rear display.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  4. Install the extension harness assembly. See Extension Harness Assembly - Center Console - Premium (Model YL) (Remove and Replace).