2025-09-11

Air Vent - B-Pillar - Upper - LH (Model YL) (Remove and Replace)

Correction code 15180101302 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Air Duct - B-Pillar - Upper - LH (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that attach the air duct to the LH B-pillar upper trim assembly
1.3 Nm (1.0 lbs-ft)
  • Torx T20 socket
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Reuse

Remove

  1. Remove the LH B-pillar air duct. See Air Duct - B-Pillar - Upper - LH (Model YL) (Remove and Replace).
  2. Remove the screws (x3) that attach the air vent to the LH B-pillar trim assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Release the locator clips (x6) that attach the air vent to the LH B-pillar trim assembly, and then remove the air vent from the trim assembly.

Install

  1. Install the locator clips (x6) that attach the air vent to the LH B-pillar trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all clips are fully engaged.
  2. Install the screws (x3) that attach the air vent to the LH B-pillar trim.
    1.3 Nm (1.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the LH B-pillar air duct. See Air Duct - B-Pillar - Upper - LH (Model YL) (Remove and Replace).