2025-09-11

1st Row Podium (Model YL) (Remove and Replace)

Correction code 13010200002 FRT 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Torque Specifications

Table 1. Torque Specifications: 1st Row Podium (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x4) that attach the 1st row podium to the body
33.5 Nm (24.7 lbs-ft)
  • 11 mm deep socket
 Replace 1616775-00-B

Remove

  1. Remove the 1st row LH and RH seat assemblies. See 1st Row Seat- LH (Remove and Install).
  2. Remove the center console duct. See Console Connect Duct (Model YL) (Remove and Replace).
  3. Remove the LH and RH B-pillar lower trims. See Trim - B-Pillar - Lower - LH (Model YL) (Remove and Replace).
  4. Remove the LH and RH front cabin carpets. See Cabin Carpet - Front - LH (Remove and Replace).
  5. Remove the clips (x4) that attach the rear cabin carpet to the body, and then fold the rear cabin carpet rearward.
  6. Remove and discard the bolts (x4) that attach the 1st row podium to the body, and remove the 1st row podium from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm deep socket

Install

  1. Align the locating tabs (x2) to the holes on the vehicle, and then install new bolts (x4) that attach the 1st row podium to the body.
    33.5 Nm (24.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm deep socket
  2. Move the rear cabin carpet back to its original position, and then install the clips (x4) that attach the rear cabin carpet to the body.
  3. Install the LH and RH front cabin carpets. See Cabin Carpet - Front - LH (Remove and Replace).
  4. Install the LH and RH B-pillar lower trims. See Trim - B-Pillar - Lower - LH (Model YL) (Remove and Replace).
  5. Install the center console duct. See Console Connect Duct (Model YL) (Remove and Replace).
  6. Install the 1st row LH and RH seat assemblies. See 1st Row Seat- LH (Remove and Install).