2025-09-11

1st Row Seat Riser (Model YL) (Remove and Replace)

Correction code 13010200102 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Torque Specifications

Table 1. Torque Specifications: 1st Row Seat Riser (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the driver seat LH seat riser to the vehicle
33.5 Nm (24.7 lbs-ft)
  • 11 mm deep socket
 Replace 1616775-00-B

Remove

  1. Remove the driver seat assembly. See 1st Row Seat- LH (Remove and Install).
  2. Remove the LH B-pillar lower trim. See Trim - B-Pillar - Lower - LH (Model YL) (Remove and Replace).
  3. Remove the clips (x4) that attach the cabin carpet to the seat riser.
  4. Fold the LH front cabin carpet forward.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift up on the rear edge of the front cabin carpet near the front of the LH outboard seat riser.
  5. Remove and discard the bolt that attaches the front of the driver seat outboard seat riser to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm deep socket
  6. Fold the LH rear main carpet rearward.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift up on the front edge of the rear main carpet near the rear of the LH outboard seat riser.
  7. Remove and discard the bolt that attaches the rear of the driver seat outboard seat riser to the vehicle, and then remove the seat riser from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm deep socket

Install

  1. Align the locating tabs (x2) to the holes on the vehicle, and position the LH outboard seat riser for installation.
  2. Install a new bolt that attaches the rear of the driver seat outboard seat riser to the vehicle.
    33.5 Nm (24.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm deep socket
  3. Install a new bolt that attaches the front of the driver seat outboard seat riser to the vehicle.
    33.5 Nm (24.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm deep socket
  4. Return the front and rear carpets back to their original positions.
  5. Install the clips (x4) that attach the cabin carpet to the seat riser.
  6. Install the LH B-pillar lower trim. See Trim - B-Pillar - Lower - LH (Model YL) (Remove and Replace).
  7. Install the driver seat assembly. See 1st Row Seat- LH (Remove and Install).