2026-04-03

Antennas and Amplifiers - TLA, Telematics Control Unit (TCU) (Remove and Replace)

Correction code 2135011022 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Informational PurposesAn informational icon, calling your attention
Note
The TCU contains the LTE module, Wi-Fi / BT module, LTE and Wi-Fi / BT antennas, and Automotive Audio Bus (A2B) transceiver. The TCU assembly must be replaced if any component fails.
  • 2026-04-03: Updated the software reinstall step.

Install

  1. Install the TCU. See Antennas and Amplifiers - TLA, Telematics Control Unit (TCU) (Remove and Install).
  2. Reinstall the software. See Software Reinstall - Touchscreen.
    Informational PurposesAn informational icon, calling your attention
    Note
    Select TCU as Resintall Type.
  3. If the TCU is equipped with an eSIM card, perform the following substeps to swap the eSIM profile.
    Informational PurposesAn informational icon, calling your attention
    Note
    For China, skip this step.
    1. Connect a laptop with Toolbox to the vehicle. See Toolbox (Connect and Disconnect).
    2. In Toolbox, click Action tab, type "Swap Dual Bootstrap eSIM operator" in the search field, and select PROC_ICE_X_DUAL-BOOTSTRAP-E-SIMvia Toolbox:(link), select kpn, and then click Run.
      Informational PurposesAn informational icon, calling your attention
      Note
      For NA and China, Do Not select kpn.
      Informational PurposesAn informational icon, calling your attention
      Note
      After the routine ends, click the "X" at the upper right corner of the prompt.
  4. Raise the LH front window and close the LH front door.