2025-09-11

ECU Mounting Bezel - 2nd Row Seat - LH (Model YL) (Remove and Replace)

Correction code 13080202502 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the LH 2nd row seat from the vehicle. See Seat Assembly - 2nd Row - LH (Model YL) (Remove and Install).
  2. Rotate the seat to access the underside.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the seat cushion is protected from damage.
  3. Disconnect the LH 2nd row seat module connectors (x4) and release the clips (x2).
  4. Remove the seat ECU mounting bezel and seat module assembly from the LH 2nd row seat by releasing the clip. After disassembling the module, remove it in the direction of the arrow.
  5. Detach the ECU mounting bezel from the seat module by releasing the clip and tabs (x2).

Install

  1. Attach the ECU mounting bezel to the seat module by securing the tabs (x2) and clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the installation is secure and properly positioned.
  2. Insert the seat ECU mounting bezel and seat module assembly into the mounting position on the LH 2nd row seat. Align and install the assembly following the direction of the arrow, then confirm that the clip is secured in place.
  3. Connect the LH 2nd row seat module connectors (x4) and secure the clips (x2).
  4. Install the LH 2nd row seat to the vehicle. See Seat Assembly - 2nd Row - LH (Model YL) (Remove and Install).