2025-09-11

Cap - Wheel (Model YL) (Remove and Replace)

Correction code 34010100002 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Equipment:
  • 2188206-00-A WHEEL TRIM REMOVAL TOOL MY_L

Remove

  1. Carefully insert the wheel cover removal tool into the gap between the wheel and the curved side of a wheel cover blade. When the tool contacts the clip tab, slightly pry upward to release the blade. Work around to disengage all the blades.
    Informational PurposesAn informational icon, calling your attention
    Note
    Keep the tool’s removal indicator aligned with the outer edge of the wheel rim.
  2. Gently pull the wheel cover to release the ring clip that attaches the wheel cover to the wheel, and then remove the cover from the vehicle.

Install

  1. Position the wheel cover over the wheel with the bottom of the Tesla "T" pointing to the valve stem, and then press the center of the cover to engage the ring clip.
  2. Press to engage the clips that attach the wheel cover blades (x7) to the wheel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all clips are properly engaged.