2025-09-11

Armrest Hinge Assembly - Center Console (Model YL) (Remove and Replace)

Correction code 15190201002 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the rear end module. See Rear End Module - Center Console (Model YL) (Remove and Replace).
  2. Remove the armrest inner assembly. See Armrest - Inner - Center Console (Remove and Replace).
  3. Remove the screws (x4) that attach the hinge assembly to the armrest outer assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  4. Remove the armrest hinge assembly from the datums (x4).

Install

  1. Install the armrest hinge assembly to the datums (x4).
  2. Install the screws (x4) that attach the hinge assembly to the armrest outer assembly.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the armrest inner assembly. See Armrest - Inner - Center Console (Remove and Replace).
  4. Install the rear end module. See Rear End Module - Center Console (Model YL) (Remove and Replace).