2025-09-18
Frame - Back Rest - Driver (Model YL) (Remove and Replace)
Correction code
13010200202
FRT
1.26
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
Seat base edges are
sharp and can cause personal injury. Wear cut resistant gloves when removing the seat
from the vehicle, and while performing procedures that involve work on or near the seat
base.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Inboard and outboard bolts (x4) that attach the seat back frame to the seat cushion frame |
 43 Nm (31.7 lbs-ft) |
|
Replace | 1128435-00-C |
Remove
- Remove the driver seat back frame. See Frame - Back Rest - Driver (Model YL) (Remove and Install).
Install
- Install the driver seat back frame. See Frame - Back Rest - Driver (Model YL) (Remove and Install).
- Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
- Unlock the vehicle gateway. See Gateway (Unlock).
- Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_VCLEFT_SEAT-CALIBRATEvia Service Mode:Low Voltage ➜ Seats ➜ Calibrate Seatvia Toolbox:(link)
- Exit Service Mode. See Service Mode.