2025-12-25
Rail Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Replace)
Correction code 1302020102 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.
- 2025-12-25: Released new procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Nuts (x8) that attach the LH 2nd row seat rail assembly from the 2nd row seat |
 28 Nm (20.6 lbs-ft) |
|
Reuse |
Remove
- Remove the LH 2nd row seat rail assembly. See Rail Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Install).
Install
- Install the LH 2nd row seat rail assembly. See Rail Assembly - 2nd Row Seat - LH (Model Y L) (Remove and Install).
- Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
- Unlock the vehicle gateway. See Gateway (Unlock).
- Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_VCSEAT2L_R2-SEAT-CALIBRATIONvia Service Mode:Low Voltage ➜ Seats ➜ Track & Armrest Calibrationvia Toolbox:(link)
- Exit Service Mode. See Service Mode.