2026-04-21

Switch - Armrest - 2nd Row Seat - LH (Model Y L) (Remove and Replace)

Correction code 13020107102 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-04-21: Released new procedure.

Remove

  1. Open the LH doors and lower the LH windows.
  2. Move the LH 1st row seat and LH 2nd row seat forward.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust the seat back if necessary to prevent contact with the headliner and other parts.
  3. Adjust the LH 2nd row seat armrest to its highest position.
  4. Release all clips (x21) that attach the inboard side shield to the LH 2nd row seat by loosening the front and rear outer clips at the backrest first, then gently pulling the assembly outward to remove.
    Informational PurposesAn informational icon, calling your attention
    Note
    Proceed carefully to avoid damage.
  5. Disconnect the LH 2nd row armrest switch connector.
  6. Release the clips (x4) that attach the armrest switch to the LH 2nd row side shield assembly, then push the switch toward inside to remove it.

Replace

  1. Secure the clips (x4) that attach the armrest switch to the LH 2nd row side shield assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    An audible click will be heard when the armrest switch is properly seated.
  2. Connect the LH 2nd row armrest switch connector.
  3. Secure the clips (x21) that attach the inboard side shield to the LH 2nd row seat.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all clips are fully seated on the LH 2nd row seat.
  4. Adjust the LH 2nd row seat armrest to its original position.
  5. Move the LH 2nd row seat and LH 1st row seat to their original positions.
  6. Raise the LH windows and close the LH doors.