2025-08-26

Tail Lamp - Liftgate (6-Seat) (Remove and Replace)

Correction code 17401800002 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Tail Lamp - Liftgate (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x4) that attach the lamp to the liftgate
4 Nm (2.9 lbs-ft)
  • Torx T30 socket
 Reuse
Nuts (x2) that attach the lamp to the liftgate
5 Nm (3.7 lbs-ft)
  • 10 mm deep socket
 Reuse
Bolts (x3) that attach the lamp to the liftgate
3.5 Nm (2.6 lbs-ft)
  • 10 mm deep socket
 Reuse

Replace

  1. Install the tail lamp assembly to the liftgate. See Tail Lamp - Liftgate (Model YL) (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    When replacing the part, since the new part comes with a new camera bracket, there is no need to install the camera bracket onto the tail lamp assembly; simply connect the trinity camera connector.
  2. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
  3. In Toolbox 3.0, perform the following steps.
    1. Click the Actions tab, type "Calibration Mode" into the search field, click PROC_DAS_X_ENTER-CALIBRATION-MODEvia Toolbox:(link), click Run, and allow the routine to complete.
    2. Click the Actions tab, type "Back Up" into the search field, click PING-HTTP_DAS_X_BACKUP-CAMERA-SCRIPTvia Toolbox:(link), change the timeout to 100, click Run, and allow the routine to complete.
    3. Click the Actions tab, type "Calibration Mode" into the search field, click PROC_DAS_X_EXIT-CALIBRATION-MODEvia Service Mode Plus:Driver Assist ➜ Cameras ➜ Exit Factory Calibration Modevia Toolbox:(link), click Run, and allow the routine to complete.
  4. Disconnect the laptop and exit Service Mode Plus. See Service Mode Plus.
  5. Raise the LH front window and close the LH front door.