2026-04-07

Correction code 16300500001 FRT NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Equipment:
  • 1467483-00-C - M3/Y Penthouse Service Insulator Kit
  • 1108272-00-B - CAP, LOGIC CONN, INV, 3DU

Remove

  1. Remove the ancillary bay cover. See Cover - Ancillary Bay (Model YL) (Remove and Install).
  2. Install the HVC logic cap.
  3. Inspect the ancillary bay for any missing insulators, and install the service insulator kit.
  4. Remove the pyro disconnect. See Pyro Disconnect - HV Battery (Remove and Replace).
  5. Disconnect the HVC connectors (x7).
  6. Lift the high voltage controller up away from the ancillary bay and release the tabs (x2), and then remove the controller from the slots (x2).
  7. Remove the high voltage controller logic cap.

Install

  1. Install the high voltage controller logic cap.
  2. Insert the high voltage controller along the location slots (x2), and then secure the tabs (x2).
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the controller is fully engaged and properly installed.
  3. Connect the HVC connectors (x7).
  4. Install the pyro disconnect. See Pyro Disconnect - HV Battery (Remove and Replace).
  5. Remove the service insulator kit.
  6. Remove the HVC logic cap.
  7. Inspect the ancillary bay cover for damage.
    Informational PurposesAn informational icon, calling your attention
    Note
    If there is any dent or depression in the sealing surface that causes it to not be flat, or any paint that comes off the ancillary bay cover, perform the ancillary bay air leak test. If the test is passed, the ancillary bay cover can be reused.
  8. Install the ancillary bay cover. See Cover - Ancillary Bay (Model YL) (Remove and Install).