2026-08-09

카메라 - 실내(탈거 및 교체)

교정 코드 17241602 0.12 메모: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 참고: 아래 절차를 수행할 때 적절한 PPE를 착용했는지 확인하려면 개인 보호의 내용을 참조하십시오.

  • 2026-06-02: Updated camera routines.
  • 2024-11-01: Added note that Service Mode must be enabled prior to connecting the replacement camera.
  • 2023-12-21: Fixed errors.

장착

  1. Enable Service Mode. See 정비 모드(활성화 및 비활성화).
    경고
    To prevent potential damage to the replacement camera, Service Mode must be enabled prior to connecting the camera.
  2. Install the upper camera cover. See 상단 커버 - 리어 뷰 미러(탈거 및 교체).
  3. For HW4 cameras:
    1. Unlock the vehicle gateway. See 게이트웨이(잠금 해제).
    2. On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Driver Assist > Cameras > Update Camera, select INTERIOR in the drop list, click Run, and allow the routine to complete.
    3. Exit Service Mode. See 정비 모드(활성화 및 비활성화).
  4. Raise the LH front window and close the LH front door.