2023-04-03

Sensor - Pressure - Door - Rear - LH (Remove and Replace)

校正代码 20200152 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

拆卸

  1. 打开左侧前车门。
  2. 打开左侧后车门。
  3. 降下左侧后车窗。
  4. 拆下左侧后车门饰板。请参阅Panel - Door Trim - Rear - LH (Remove and Replace)
  5. 断开左侧后车门压力传感器电气连接器。
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    切勿向下按红色锁片。拉动红色锁片进行解锁,然后再次拉动以松开连接器。
  6. 逆时针转动左侧后车门压力传感器,然后从封闭板上拆下传感器。

安装

  1. 将左侧后车门压力传感器放在封闭板上,然后顺时针转动,将传感器固定到封闭板。确认传感器锁定到位。
  2. 连接左侧后车门压力传感器电气连接器。
    Informational PurposesAn informational icon, calling your attention
    卡入锁片。
  3. 安装左侧后车门饰板。请参阅Panel - Door Trim - Rear - LH (Remove and Replace)
  4. 升起左侧后车窗。
  5. 关闭左侧后车门。
  6. 关闭左侧前车门。