闩锁 - 掀背车门(拆卸和更换) ((拆卸和更换))
校正代码
11355002
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make
sure wearing proper PPE when performing the below procedure.
- Open liftgate
-
Remove lower liftgate trim
注8x clips, 2x connectors, Be careful not to hang or drop quickly to prevent damage to connectors
-
Release liftgate latch power release cable from liftgate
注1x holding tab
-
Disconnect liftgate latch power release connector
注1x connector
-
Remove bolts securing liftgate latch power release to liftgate
注2x bolts, T30, 10 Nm
-
Remove liftgate latch power release from liftgate and release liftgate high force cinching actuator cable
注2x holding tabs
-
Connect liftgate high force cinching actuator cable to liftgate latch power release and position into liftgate
注2x holding tabs
-
Install bolts securing liftgate latch power release to liftgate
注2x bolts, T30, 10 Nm
-
Connect liftgate latch power release connector
注1x connector
-
Install liftgate latch power release cable to liftgate
注1x holding tab
-
Install lower liftgate trim
注8x clips, 2x connectors
- Close liftgate