校正代码 12201006 0.30 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至ServiceManualFeedback@tesla.com。 注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。注意：请参阅人体工程学注意事项查看安全健康的作业规程。

1. Clean the liftgate area with isopropyl alcohol. Allow 1 minute to dry.
   注

   If the area requires any paint correction, request assistance from the shop detailer before installation.

   

2. Line up the spoiler alignment jigs with the edgses of the liftgate.
   TIp

   Tape the jigs down as needed.

   

   

3. Perform a dry fit of spoiler. Adjust the jigs as needed to center the spoiler.

   

   

   

4. Peel away the adhesive tape and install the spoiler. Apply pressure from the center and work outwards.
   注

   Verify that the spoiler is fully adhered.

   

5. Remove the spoiler alignment jigs.

   

6. Verify that the spoiler is properly installed. Wipe away any excess debris.