05/03/2024 08:54:23

挡泥板 - 前侧和后侧（改装）

校正代码 12203306 0.24

Special tools required for this procedure:

1465974-00-A - Tool, Pressure Roller

程序

  1. Make sure the vehicle is parked on a flat level surface.
  2. 打开左前车门，降下左前车窗。
  3. Press the brake pedal to turn on the drive rails.
  4. Set the air suspension to "Very High".
    Informational PurposesAn informational icon, calling your attention
    注
    On the vehicle touchscreen, touch Controls > Suspension > Very High.
  5. Enable "Jack Mode" to disable the self-leveling feature of the air suspension.
    Informational PurposesAn informational icon, calling your attention
    注
    On the vehicle touchscreen, touch Controls > Service > Jack Mode.
  6. Clean the LH inner front fender panel surface with Isopropyl Alcohol (IPA) wipes.
  7. Install the LH front fender flare onto the LH front fender panel.
    1. Remove the backing that covers the double-sided tape on the fender flare.
    2. Align the fender flare onto vehicle.
      Informational PurposesAn informational icon, calling your attention
      注
      Use the front edge of the LH front fender together with the LH side upper edge of the front fascia to align the fender flare.
    3. Use the pressure roller tool (1465974-00-A) to ensure proper adhesion of the double-sided tape onto the inner LH front fender panel.
  8. Repeat steps 6 and 7 to install the RH front fender flare.
  9. Clean the LH inner rear quarter panel surface with IPA wipes.
  10. Install the LH rear fender flare onto the LH rear quarter panel.
    1. Remove the backing that covers the double-sided tape on the fender flare.
    2. Align the fender flare onto vehicle.
      Informational PurposesAn informational icon, calling your attention
      注
      Use the rear edge of LH quarter panel together with the LH side edge of the rear fascia to align the rear fender flare.
    3. Use the pressure roller tool (1465974-00-A) to ensure proper adhesion of the double-sided tape onto the inner LH rear quarter panel.
  11. Repeat steps 9 and 10 to install the RH rear fender flare.
  12. Press the brake pedal, and then deactivate Jack Mode by touching Controls > Service > Jack Mode again.
  13. Set the air suspension to "Medium".
    Informational PurposesAn informational icon, calling your attention
    注
    On the vehicle touchscreen, touch Controls > Suspension > Medium.
  14. 升起左前车窗，关闭左前车门。