2023-07-14

Applique - Liftgate (Global) (Remove and Replace)

校正代码 12207022 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
This procedure is for the Global Refresh version of this part. The procedure for the Original version of this part is here: Applique - Liftgate (Remove and Replace).

拆卸

  1. Carefully release the clips (x5) that attach the liftgate applique to the liftgate, and then remove the applique from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Use a plastic trim tool to release the clips.

安装

  1. Clean the mating surfaces of the liftgate applique with an Isopropyl Alcohol (IPA) wipe.
    Informational PurposesAn informational icon, calling your attention
    Clean away any residue.
    Informational PurposesAn informational icon, calling your attention
    Use your thumb to help roll off the adhesive.
    Informational PurposesAn informational icon, calling your attention
    Allow 1 minute for the IPA to dry before continuing to the next step.
  2. Install the applique tape onto the applique bracket.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Be wary not to cover the rear facing camera.
    Informational PurposesAn informational icon, calling your attention
    Peel away the tape when the liftgate applique is to be installed
  3. Install the liftgate applique.
    Informational PurposesAn informational icon, calling your attention
    x5 clips.
    Informational PurposesAn informational icon, calling your attention
    Peel away the tape when ready to install the applique.
    Informational PurposesAn informational icon, calling your attention
    Align the applique using pin. Start by fastening the center clips, and then work your way out.
    Informational PurposesAn informational icon, calling your attention
    Use the seam roller to seat the adhesive areas.