校正代码 170100080.06 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。 注意：执行下述程序时，请参阅人员保护确认已穿戴适当的个人防护装备 (PPE)。

1. Remove the rear underhood apron. See 前备箱挡板 - 后部（拆卸和更换）.
2. Disconnect LV battery connector and keep FRL loop connected
   注

   1x connectors, Release LV battery but keep FRL loop connected, Lift up and release green locking tab, Pull black connector lock outwards to release connection

   

   

3. Connect 12V maintainer while LV battery is connected and cycle contactors on
   注

   Connect 12V support while LV battery is connected, Place fender cover over multi-system beam, Prevent shorting position cable to ground, Secure positive terminal to jump post, Secure negative terminal to chassis ground, Contactors will turn on and there will be an audible click

   

   

4. Secure LV battery connector
   注

   1x connector, Seat LV battery connection and push black connector lock inwards to secure, Engage upper locking tab when fully seated

   

5. Open LH front door

   

6. Lower LH front window

   

7. Place vehicle in service mode via UI
   注

   Via Controls > Software, Touch and hold "Model" for 2 seconds then release, Use screen keyboard to type "service" into dialog box and select OK button

   

   

   

8. Remove 12V maintainer
   注

   Unplug maintainer first and then remove from posts, Return cap to positive post

   

   

9. Navigate to Power Distribution
   注

   Via Service UI select Low Voltage > Power Distribution

   

   

10. 确认低压电池的状态。
    注

    如果功率转换系统 (PCS) 支持启用 2 分钟后，出现VCLEFT_a478_LVBMS_MOSFET_Open或VCBATT_a478_LVBMS_MOSFET_Open警告，说明低压电池尚未自动恢复。可以通过触摸屏或 Toolbox 尝试手动进行自动恢复：

    • 触摸屏：Service Mode > Low Voltage > Power Distribution > Close MOSFET
    • Toolbox：运行ActionPROC_VCFRONT_X_RECONNECT-LV-BATTERYSearch for routine in ToolboxLVBMS Reconnect LV BatteryLow Voltage / Power Distribution - Close MOSFET

    注

    如果通过上述步骤并未成功完成低压电池自动恢复，请使用 Tesla 锂离子电池充电器（仍在开发中）进行电池恢复。

    • 确认电池并未处于高电流放电或自保护状态。
    • 转至Service Mode > Low Voltage > Power Distribution > LV Battery，确认低压电池充电状态在上升。
    • 确认低压电池 MOSFET 状态为Closed。
11. Exit Service mode
    注

    Press and hold the Exit Service Mode button for 3 seconds

    

12. Install the rear underhood apron. See 前备箱挡板 - 后部（拆卸和更换）.