2024-06-17

TESLA Letter Badge (Install)

校正代码 12055302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

  • 2024-06-11: Added the jig tool number.
  • 2004888-00-A - JIG, REAR APPLIQUE LETTERING, MSP2

程序

  1. Clean the liftgate area where the TESLA letter badge is to be installed with an isopropyl alcohol (IPA) wipe.
    Informational PurposesAn informational icon, calling your attention
    Allow 1 minute dry time.
  2. Put the jig (2004888-00-A) in position on the liftgate and secure it to liftgate applique bracket with masking tape.
    Informational PurposesAn informational icon, calling your attention
    For better adhesion of masking tape, make sure area is clean. Jig will not be perfectly centered with license plate.
  3. Position the lettering onto liftgate applique bracket.
    Informational PurposesAn informational icon, calling your attention
    Make sure jig datums are at top of template holes.
  4. Remove the adhesive backing film from lettering, and then adhere the lettering onto liftgate applique. Press each letter for initial adhesion, and then apply pressure and allow each letter to fully adhere, remove film after.
  5. Visually inspect the badge, making sure it is correctly installed.