2024-12-16

Blower Motor - HVAC (Remove and Replace)

校正代码 18103202 1.02 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

  • 2024-12-06: 添加了拆卸和安装鼓风机电机的视频。

拆卸

  1. 拆下仪表板分总成。请参阅Sub Assembly - Instrument Panel (Remove and Install)
  2. 拆下驾驶位仪表板风管。请参阅Duct - Instrument Panel - Driver (Remove and Replace)
  3. 断开 HVAC 鼓风机电机电气连接器,然后松开将鼓风机电机线束固定到 HVAC 总成的夹子(2 个)。
  4. 拆下将 HVAC 鼓风机电机固定到 HVAC 总成的螺钉(3 个)。
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    使用 T20 钻头、迷你棘轮和 1/2 切割钻头套件加长件。
  5. 向上绕 HVAC 总成转动 HVAC 鼓风机电机,将其从车辆上拆下。

安装

  1. 将 HVAC 鼓风机电机放置到车辆上。
    Informational PurposesAn informational icon, calling your attention
    向下绕 HVAC 总成转动鼓风机电机。
  2. 安装将 HVAC 鼓风机电机固定到 HVAC 总成的螺钉(3 个)。
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    使用 T20 钻头、迷你棘轮和 1/2 切割钻头套件加长件。
  3. 连接 HVAC 鼓风机电机电气连接器,然后紧固将鼓风机电机线束固定到 HVAC 总成的夹子(2 个)。
  4. 安装驾驶位仪表板风管。请参阅Duct - Instrument Panel - Driver (Remove and Replace)
  5. 安装仪表板分总成和所有为便于操作而拆下的其他零件。请参阅Sub Assembly - Instrument Panel (Remove and Install)