2022-06-17

Bracket - Radar - Front (Remove and Replace)

校正代码 17201802 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

扭矩规格

表 1. 扭矩规格Bracket - Radar - Front (Remove and Replace)
描述 扭矩值 推荐工具 重新使用/更换 备注
将雷达支架固定到车辆的螺栓(3 个)
5 Nm (3.7 lbs-ft)
  • 10 毫米套筒
  • 2 英寸加长件
  • 回旋头棘轮/回旋头扭矩扳手
重新使用

安装

  1. Remove the front fascia. See: Fascia Assembly - Front (Remove and Install).
  2. Disconnect the electrical harness from the radar.
  3. Release the tab that attaches the radar to the radar bracket.
  4. Remove the three bolts that attach the radar bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use one hand to hold the bracket steady while removing the bolts to prevent the bracket from flexing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    推荐使用以下工具:
    • 10 毫米套筒
    • 2 英寸加长件
    • 回旋头棘轮/回旋头扭矩扳手

安装

  1. 5 Nm (3.7 lbs-ft)
    将雷达支架放到车上,然后安装将雷达支架固定到车辆的螺栓。
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use one hand to hold the bracket steady while removing the bolts to prevent the bracket from flexing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    推荐使用以下工具:
    • 10 毫米套筒
    • 2 英寸加长件
    • 回旋头棘轮/回旋头扭矩扳手
  2. Position the radar into the bottom of the radar bracket, and then install the radar to the top radar bracket clip.
  3. Connect the electrical harness to the radar.
  4. Install the front fascia. See Fascia Assembly - Front (Remove and Install).
  5. Perform the radar calibration. See .