校正代码 13050006 0.40 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。 注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。

1. Open all four doors
2. Lower LH front window
3. Move LH front seat forward
4. Move RH front seat forward
5. Remove LH side bolster trim
   注

   1x clip, 1x tab, Start by releasing upper portion

   

   

   

6. Remove RH side bolster trim
   注

   1x clip, 1x tab, Start by releasing upper portion

   

   

   

7. Remove 2nd row seat cushion assembly
   注

   2x clips, 2x connectors, Disengage locking clips and lift up on seat cushion, Release connections, If 2nd row seats are folded down then fold up for time being

   

   

   

   

   

8. Remove 2nd row LH side isofix bracket
   注

   2x bolts, 11mm, 26 Nm, Discard after removal

   

9. Remove 2nd row RH side isofix bracket
   注

   2x bolts, 11mm, 26 Nm, Discard after removal

   

10. Prepare LH and RH 2nd row isofix flap for installation
    注

    4x tabs, Trim off locator tabs along yellow line, Note: this results in no self location of the assembly while fitting mounting screws.

    

    

    

11. Trim back LH NVH foam
    注

    Test fit isofix assembly and cut off trim from impressions left in NVH surface

    

    

    

    

    

12. Trim back RH NVH foam
    注

    Test fit isofix assembly and cut off trim from impressions left in NVH surface

    

    

    

    

    

13. Install new LH 2nd row isofix assembly
    注

    2x patch bolts, 11mm, 26 Nm, Install new fasteners

    

    

14. Install new RH 2nd row isofix assembly
    注

    2x patch bolts, 11mm, 26 Nm, Install new fasteners

    

    

15. Install new 2nd row seat cushion assembly
    注

    2x clips, 2x connectors, Secure connections and slide seat belt buckles through seat cushion, Tuck seat cushion and foam into place, Engage clips

    

    

    

    

    

16. Install LH side bolster trim
    注

    1x clip, 1x tab, Replace clip if damaged, Hook bottom portion and then secure the top

    

    

17. Install RH side bolster trim
    注

    1x clip, 1x tab, Replace clip if damaged, Hook bottom portion and then secure the top

    

    

18. Move RH front seat to original position
19. Move LH front seat to original position
20. Raise LH front window
21. Close all four doors