18/12/2023 19:33:38
流线型仪表板 - 仪表板（拆卸和更换）
校正代码
14050012 1.20
注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。
注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。
注意：执行下述程序时，请参阅人员保护确认已穿戴适当的个人防护装备 (PPE)。
- 2023-12-11: Added IP sub assembly step.
- 2023-03-31: Added note on reworked datums/mounting tabs.
注
Replacement aero lens assemblies may have had certain datums/mounting tabs removed. This
is normal and does not negatively affect vehicle functionality.
拆卸
- Remove the IP sub assembly. See 次总成 - 仪表板（拆卸和安装）.
- Remove the driver instrument panel air vent. See 通风口 - 仪表板 - 驾驶位（左侧驾驶）（拆卸和更换）.
-
Remove the screws (x4) that attach the
front passenger instrument panel air vent to the aero lens assembly, and then remove the
air vent from the assembly.
2 Nm (1.5 lbs-ft)提示： Use of the following tool(s) is recommended:- T20 socket
-
Release the clip that attaches the LH
instrument panel aero lens cover to the aero lens assembly, and then remove the cover
from the assembly. Repeat this step for the RH aero lens cover.
图 1. LH shown; RH similar 
图 2. LH shown; RH similar 
安装
-
Position the LH instrument panel aero lens cover to the aero lens assembly, and then
secure the clip that attaches the cover to the assembly. Repeat this step for the RH
aero lens cover.
图 3. LH shown; RH similar
图 4. LH shown; RH similar
-
Position the front passenger instrument panel air vent onto the aero lens assembly,
and then install the screws (x4) that attach the air vent to the assembly.2 Nm (1.5 lbs-ft)提示： Use of the following tool(s) is recommended:
- T20 socket
-
Install the driver instrument panel air vent. See 通风口 - 仪表板 - 驾驶位（左侧驾驶）（拆卸和更换）.
注It is not necessary to run the "Airwave" routine as instructed at the end of the air vent install.
- Install the IP sub assembly. See 次总成 - 仪表板（拆卸和安装）.