Light - Fog - Front - LH (Remove and Replace)
校正代码
17404002
0.48
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See 平均维修工时 to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure proper PPE is worn when
performing the below
procedure.
扭矩规格
描述 | 扭矩值 | 推荐工具 | 重新使用/更换 | 备注 |
---|---|---|---|---|
将雾灯固定到前饰板总成的螺钉 |
2.8 Nm (2.1 lbs-ft) |
|
重新使用 |
拆卸
- Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
-
Remove the three screws that attach
the fog light to the front fascia assembly.
TIp推荐使用以下工具:
- 梅花 T25 套筒
- 4 英寸加长件
- 回旋头棘轮/回旋头扭矩扳手
- Release the four clips that attach the fog light to the front fascia assembly, and then remove the fog light from the front fascia assembly.
更换
- Position the fog light on the front fascia assembly, and then install the four clips that attach the fog light to the front fascia assembly.
-
安装将雾灯固定到前饰板总成的三个螺钉。2.8 Nm (2.1 lbs-ft)TIp推荐使用以下工具:
- 梅花 T25 套筒
- 4 英寸加长件
- 回旋头棘轮/回旋头扭矩扳手
- Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).