校正代码 17201612 0.36 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。 注意：执行下述程序时，请参阅人员保护确认已穿戴适当的个人防护装备 (PPE)。

1. Open the LH front door.
2. Lower the LH front window.
3. Remove the front fascia assembly. See 饰板总成 - 前（拆卸和安装）.
4. Disconnect the front radar sensor connector.
   提示： Use of the following tool(s) is recommended:

   • Small flat head screwdriver

   

   

5. Install the dummy plugs (x2) on the front radar sensor and the sensor connector.

   

6. Use harness tape to attach the front radar sensor connector to the frunk harness.
   提示： Use of the following tool(s) is recommended:

   • Harness tape

   

   

7. Install the front fascia assembly. See 饰板总成 - 前（拆卸和安装）.
8. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3（连接和断开）.
9. In Toolbox, click the Dashboards tab, Infotainment Dashboard, and then Vehicle Configuration.
   注

   Configuration values should load automatically, if not click Read Config and Run to load configuration values.
10. In Toolbox, navigate to "forwardRadarHw", click on the current front radar configuration, and then change the configuration to "NONE".
11. In Toolbox, click Apply Changes and Run to save the updated front radar configuration.
    注

    The center display will reboot and Toolbox connection will be lost. Select "X" at top right of window to close once complete.
12. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3（连接和断开）.
13. Raise the LH front window.
14. Close the LH front door.