2023-04-03

System - Windshield Washer (Remove and Replace)

校正代码 17501152 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

拆卸

  1. 拆下前备箱后部挡板。请参阅Underhood Apron - Rear (Remove and Replace)
  2. 拆下前备箱左侧挡板。请参阅Underhood Apron - LH (Remove and Replace)
  3. 将减震塔软管与清洗器箱软管断开。
  4. 举升并支撑车辆。请参阅Raise Vehicle - 2 Post Lift
  5. 拆下左侧前车轮。请参阅Wheel Assembly (Remove and Install)
  6. 松开将左侧前轮罩内衬的前部连接到车辆上的卡子(7个)。
  7. 将电线线束从清洗器系统断开,并松开将线束连接到车辆的卡子(3 个)。
  8. 拆下喇叭总成。请参阅Horn Assembly (Remove and Replace)
  9. 拆下将瓶颈连接到车辆的卡子。
  10. 拆下将清洗器系统固定到车辆的螺母(3 个)。
  11. 将清洗器系统从车辆拆下。

安装

  1. 将清洗器系统放置到车辆上的安装点。
  2. 安装将清洗器系统连接到车辆的螺母(3 个)。
    Informational PurposesAn informational icon, calling your attention
    3 个螺母,10 毫米,5Nm
  3. 安装将瓶颈连接到车辆的卡子。
  4. 安装喇叭总成。请参阅Horn Assembly (Remove and Replace)
  5. 将电线线束连接到清洗器系统,并安装将线束连接到车辆的卡子(3 个)。
  6. 安装将左侧前轮罩内衬前部固定到车辆的卡子。
  7. 安装左侧前车轮。请参阅Wheel Assembly (Remove and Install)
  8. 将车辆驶离举升机。
  9. 将减震塔软管连接到清洗器箱软管。
  10. 安装前备箱左侧挡板。请参阅Underhood Apron - LH (Remove and Replace)
  11. 安装前备箱后部挡板。请参阅Underhood Apron - Rear (Remove and Replace)
  12. 对清洁器储液罐进行充注。
    Informational PurposesAn informational icon, calling your attention
    TIp
    储液罐容量为 4.5 升。