2023-04-02

Shroud - Upper - Steering Column (Remove and Replace)

校正代码 14053702 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
警告
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

拆卸

  1. 打开左侧和右侧前车门。
  2. 降下左侧和右侧前车窗。
  3. 拆下A 柱左侧和右侧中部饰板。请参阅Trim - A-Pillar - Middle - LH (Remove and Replace)
  4. 拆下左侧和右侧仪表板端盖。请参阅End Cap - Instrument Panel - LH (Remove and Replace)
  5. 将转向柱移至最后部,压至最底部。
  6. 打开前备箱盖。
  7. 拆下前备箱后部挡板。请参阅Underhood Apron - Rear (Remove and Replace)
  8. 断开低压电源。请参阅LV Power (Disconnect and Connect)
  9. 将中央控制台的手机托盘总成拆下,但无需移动手机托盘内的感应式充电器。请参阅Phone Dock - Center Console (Remove and Replace)
  10. 将仪表板维修面板总件拆下,但不拆下维修面板上的车舱温度传感器风扇。请参阅Service Panel - Instrument Panel (Remove and Replace)
  11. 将触摸屏总成拆下,但不拆下触摸屏上的显示机制。请参阅Touchscreen (HW3) (Remove and Replace)
  12. 拆下主仪表板。请参阅Decor - Instrument Panel - Main (Remove and Replace)
  13. 拆下驾驶位气囊。请参阅Airbag - Driver (Remove and Replace)
  14. 拆下 yoke 方向盘/方向盘。请参阅Steering Yoke/Wheel (Remove and Replace)
  15. 向上拉动以松开连接上转向柱护罩和下护罩的卡子(6 个)。
  16. 松开将转向柱上部间隙隔板固定到转向柱护罩的卡子 (4 个)。

安装

  1. 紧固将间隙隔板固定到转向柱护罩的卡子(4 个)。
  2. 对齐卡子(6 个)和基线,然后向下按压,将上护罩安装到下护罩上。
  3. 安装 yoke 方向盘/方向盘。请参阅Steering Yoke/Wheel (Remove and Replace)
  4. 安装驾驶位气囊。请参阅Airbag - Driver (Remove and Replace)
  5. 安装主仪表板饰板。请参阅Decor - Instrument Panel - Main (Remove and Replace)
  6. 安装触摸屏。请参阅Touchscreen (HW3) (Remove and Replace)
  7. 安装仪表板维修面板。请参阅Service Panel - Instrument Panel (Remove and Replace)
  8. 安装中控台手机托盘。请参阅Phone Dock - Center Console (Remove and Replace)
  9. 连接低压电源。请参阅LV Power (Disconnect and Connect)
  10. 安装前备箱后部挡板。请参阅Underhood Apron - Rear (Remove and Replace)
  11. 将转向柱恢复原位。
  12. 安装左侧和右侧仪表板端盖。请参阅End Cap - Instrument Panel - LH (Remove and Replace)
  13. 安装 A 柱左侧和右侧中部饰板。请参阅Trim - A-Pillar - Middle - LH (Remove and Replace)
  14. 升起左侧和右侧前车窗。
  15. 关闭左侧和右侧前车门。