01/03/2023 07:38:17

Diskanthøyttalerenhet– fordør – venstre (med festestropp) (fjerne og skifte ut)

Korrigeringskode 21212732 0.24 MERK: Hvis ikke noe annet er uttrykkelig oppgitt i prosedyren, gjenspeiler korrigeringskoden og FRT ovenfor alt arbeidet som kreves for å gjennomføre denne prosedyren, inkludert de tilknyttede prosedyrene. Ikke stable korrigeringskoder med mindre du bli uttrykkelig bedt om det.MERK: Se Flat rate-tider for å lære mer om FRT-er og hvordan de lages. Hvis du vil gi tilbakemelding om FRT-verdier, kan du sende en e-post til LaborTimeFeedback@tesla.com. MERK: Se Personlig beskyttelse for å forsikre deg om at du bruker riktig PVU når du gjennomfører prosedyren nedenfor.

Fjerne

  1. Open the LH front door and lower the LH front window.
  2. Carefully release the clips (x2) and body hook that attach the LH front door tweeter assembly to the door trim panel and body, disconnect the connector, and then hang the assembly aside.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Release the tweeter assembly upwards to release the clips.
    Informational PurposesAn informational icon, calling your attention
    Merk
    The tether will still be connected.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Tethered units can be used to replaced non-tethered tweeters. However, if the vehicle is equipped with a tethered tweeter, then it must be replaced with a tethered unit in all instances.
  3. Remove the LH front door trim panel. See Panel – dørkledning – foran – venstre (fjerne og montere).
  4. Take note of the tether routing, and then unhook the tether to remove the LH front door tweeter assembly from the door assembly.

Montere

  1. Position the LH front door tweeter onto the door assembly, feed the strap in, secure it over the body hook, and then hang the tweeter assembly aside.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Make sure the tether stays in the position circled in red.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Install the tether using the routing noted during removal.
    Tips: Use a trim to aid in installation if needed.
  2. Install the LH front door trim panel. See Panel – dørkledning – foran – venstre (fjerne og montere).
  3. Position the LH front door tweeter assembly onto the door panel, connect the connector, and then secure the clips (x2) and hook that attach the assembly to the door panel and body.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Make sure the component is fully engaged and the tether is not exposed from under the trim.
  4. Raise the LH front window and close the LH front door.