2026-11-05

轮拱内衬 - 前 - LH（拆卸和更换）

校正代码 12010902 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure. NOTE: See 人体工程学注意事项 for safe and healthy working practices.

    Equipment:
    • 1133569-00-A 卡子拆卸钳

    扭矩规格

    Table 1. 扭矩规格： 轮拱内衬 - 前 - LH（拆卸和更换）
    描述 扭矩值 推荐工具 重复使用/更换 备注
    将左侧前轮拱内衬固定到车辆的螺栓
    5 Nm (3.7 lbs-ft)
    • 10 毫米套筒扳手
    		 重复使用

    拆卸

    1. Remove the LH front wheel. See 轮毂（拆卸和安装）.
    2. Remove the bolt and release the clips (x18) that attach the LH front wheel arch liner to the vehicle, and then remove the liner from the vehicle.
      5 Nm (3.7 lbs-ft)
      Note
      Newer vehicles might have fewer fasteners than pictured.
      Note
      推荐使用以下工具
      • 10 毫米套筒扳手

    安装

    安装程序与拆卸程序相反。