2025-03-21

Connector - Pedestrian Warning Speaker (CN) (Remove and Replace)

校正代码 171007520.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure.

拆卸

  1. 拆下右前轮毂。请参阅Wheel Assembly (Remove and Install)
  2. 拆下将右前轮拱内衬固定到饰板的卡子(9 个),然后将轮毂内衬置于一旁,以便操作。
  3. 拆下将线束固定到行人警示扬声器总成的夹子。
  4. 将红色锁片从连接器滑离以将其松开;然后下压灰色锁片以松开行人警示扬声器连接器。
    Informational PurposesAn informational icon, calling your attention
    The connector access may vary depending on the version of the super horn audio speaker installed on the vehicle. You may need to use a pocket screwdriver or a miniature pick to release the red locking tab, which is covered by an anti-tampering feature.
  5. 拆下连接器锁盖,然后向下拉动线束并同时下压卡销(2 个),将连接器从车辆上拆下。

安装

  1. 将卡销(2 个)插入连接器,然后安装连接器锁盖。
    Informational PurposesAn informational icon, calling your attention
    执行推拉推测试,确认卡销已完全就位。
  2. 连接行人警示扬声器连接器。
  3. 安装将线束固定到行人警示扬声器总成的夹子。
  4. 安装将右前轮毂内衬固定到饰板的卡子(9 个)。
  5. 安装右前轮毂。请参阅Wheel Assembly (Remove and Install)