04/06/2024 21:10:10
前照灯（SAE 标准至全球版） - 前照灯总成 - 成对（改装）
校正代码
17400106 0.72 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则不要堆叠校正代码。注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。
警告
尽管此程序已经过验证，但仍是一个草案。可能没有警告和注意事项。请遵守安全要求，处理或靠近高压系统和部件时，请谨慎对待。请将校正内容及反馈发送至 ServiceDevelopment@teslamotors.com。
注
Refer to TN-24-17-002 for additional headlamp retrofit information.
改装
- Open the LH front door.
- Lower the LH front window.
- Remove the LH and RH headlights. See 前照灯 - LH（拆卸和更换）.
-
Install the new LH and RH headlights. See 前照灯 - LH（拆卸和更换）.
注Do not adjust the headlights at this time. Headlight adjustment will be performed later in this procedure.
- If not already performed, enable Service Mode through the touchscreen. See 维护模式.
- Enable Service Mode +. See 维护模式增强版.
-
In Toolbox 3, go to , and then change the "headlamps" configuration to "GLOBAL".
注If you do not see this configuration displayed, update the vehicle to software version 2024.20 or later.
- On the vehicle touchscreen, perform a software reinstall concurrently with the rest of the steps in this procedure. See 软件重新安装 - 触摸屏.
-
If the vehicle is equipped with a Virtual Pitch Sensor (VPS), in Toolbox 3, click the Actions tab, search for “PROC_ICE_X_SET-VIRTUAL-PITCH-SENSOR”, and then click Change leveling system of Virtual Pitch Sensor.
注Make sure the vehicle is running firmware version 2024.8.9 or later to run this routine.
- Click Run and allow the routine to complete. Click X at the top right of the window to exit once the routine is complete.
-
In Toolbox 3, go to and confirm the "headlightLevelerType" configuration is "VIRTUAL_PITCH_SENSOR".
- Disconnect the laptop from the vehicle. See Toolbox 3（连接和断开）.
- Adjust the headlights. See 前照灯 - 调节 - 全球（工具法）.
- Disable Service Mode through the touchscreen. See 维护模式.
- Raise the LH front window.
- Close the LH front door.