2023-10-22

Actuator - Upper Mode (Heat Pump) (Remove and Replace)

校正代码 18102612 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure.

  • 2023-10-16: Reorganized the procedure.

拆卸

  1. Remove the glove box. See Glove Box - With Knee Airbags (Heat Pump) (Remove and Replace).
  2. Disconnect RH upper duct thermistor from RH air wave duct
    Informational PurposesAn informational icon, calling your attention
    1x connector
  3. Remove the RH air wave duct. See Duct - Air Wave - RH (LHD) (Remove and Replace).
  4. Release the IP harness clip next to the RH upper mode actuator.
  5. Disconnect the upper mode actuator connector.
  6. Remove the bolts (x2) that attach the upper mode actuator to the HVAC assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    推荐使用以下工具:
    • 6 毫米套筒
    • 4 英寸加长件
    • 回旋头棘轮/回旋头扭矩扳手
  7. Remove the upper mode actuator from the HVAC assembly.

安装

  1. Position the upper mode actuator to the HVAC assembly for installation.
    Informational PurposesAn informational icon, calling your attention
    Align the guide and push the upper mode actuator toward the HVAC assembly.
  2. Install the bolts (x2) that attach the upper mode actuator to the HVAC assembly.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    推荐使用以下工具:
    • 6 毫米套筒
    • 4 英寸加长件
    • 回旋头棘轮/回旋头扭矩扳手
  3. Connect the upper mode actuator connector.
  4. Install the IP harness clip next to the RH upper mode actuator.
  5. Remove the RH air wave duct. See Duct - Air Wave - RH (LHD) (Remove and Replace).
  6. Connect the RH upper duct thermistor to the RH air wave duct.
    Informational PurposesAn informational icon, calling your attention
    1x connector
  7. Install the glove box. See Glove Box - With Knee Airbags (Heat Pump) (Remove and Replace).