Hose - Washer - Reservoir (RHD) (Remove and Replace)
校正代码
17501352
0.66
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure wearing proper PPE when
performing the below procedure.
扭矩规格
描述 | 扭矩值 | 推荐工具 | 重复使用/更换 | 备注 |
---|---|---|---|---|
Bolts that attach the water tank to the vehicle |
![]() 3 Nm (2.2 lbs-ft) |
|
重复使用 |
拆卸
- 打开驾驶位车门。
- 拆下前备箱后部挡板。请参阅Underhood Apron - Rear (Remove and Replace)。
- 拆下座舱进气槽。请参阅Duct - Cabin Intake (Remove and Replace)。
- 拆下前备箱盖锁盖。请参阅Cover - Hood Latch (Remove and Replace)。
- 拆下前备箱储物单元。请参阅Underhood Storage Unit (Remove and Replace)。
- 拆下 LH 和 RH 雨刮器臂。请参阅Wiper Arms (Remove and Replace)。
- 拆下前围篦板。请参阅Panel - Cowl Screen (Remove and Replace)。
- 松开将电气线束固定到挡风玻璃清洗器储液罐的夹子。
- 断开电气线束与挡风玻璃清洗器储液罐连接器的连接。
- 拆下 LH 前轮毂。请参阅Wheel Assembly (Remove and Install)。
- 拆下 LH 前轮拱内衬。请参阅Wheel Arch Liner - Front - LH (Remove and Replace)。
- 拆下将挡风玻璃清洗器储液罐固定到车身的下部螺栓。
- 降下车辆,直至轮胎刚好接触到地面。
- 拆下将挡风玻璃清洗器储液罐固定到车身的上部螺栓。
- 从车上拆下挡风玻璃清洗器储液罐,然后回注临时排出的清洗液。
-
从清洗器泵上断开清洗器软管,然后从清洗器储液罐上拆下软管。
注旋转清洗器泵以便断开软管。
安装
安装程序与拆卸程序相反,以下各项除外:
- 安装完成后,向挡风玻璃清洗器储液罐充注挡风玻璃清洗液。
- 确认挡风玻璃清洗器和雨刮器可以正常工作。